Can't get precise z Data.

Frequent questions asked online, offline, in forums are answered here
Post Reply
mustafa_soliman
Posts: 1
Joined: Fri May 15, 2020 9:02 am

Can't get precise z Data.

Post by mustafa_soliman »

Hi,

I wanted to make a 3D map in 20m x 20m x 4 m area.
I am using HW4.9 for stationary beacons and HW4.9 with IMU for the mobile beacon on tripod.
4 beacons at heights of 50 cm from the ground facing each other and the other 2 are on height of 4 meter from ground
NIA configuration.
I enter coordinates manually
I used 3 configurations
4 beacons in 2D mode
4 beacons in 3D navigation mode
and 6 beacons (as stated in the manual).
No. of periods 5
The stationary beacons always are checked for communication with mobile beacon by an oscilloscope.

I am using ROS to collect the data for analysis.
And I have some results

I could get 10 cm accuracy in the xy direction in all position in that area.
but z direction is not accurate at all and I have some questions.

1- when I call the raw data from ROS in 3D maps, it just give the data of submap 1, the vertical map only.
can we call the raw distance for all beacons ?
2- In x,y level. The accuracy decrease when the mobile beacon approach the horizontal level map of the beacon.
Except in 2D mode 4 beacons.
3- In the vertical level the accuracy is high only when you approach the vertical plan of the beacons, when you go away from it it decrease.
4- the data is stoped in 3D maps when we approach the horizontal. exactly after the mobile beacon make vertex angle of pyramid more than 160 degrees.

Any Explanation for the position error? I hope there is debugging tools like saving the mobile beacon - stationary beacon distances
via Dashboard or ROS.

Alexander_Marvelmind
Posts: 23
Joined: Tue Mar 20, 2018 12:46 pm

Re: Can't get precise z Data.

Post by Alexander_Marvelmind »

Hello,

Writing you about the Z precision:

- Fist of all, please check our Operating Manual - https://marvelmind.com/pics/marvelmind_ ... manual.pdf - 9.9 System Accuracy Evaluation chapter

- We have a special installation for Stable Z. Please check details about Vertical Z in the Placement Manual - https://marvelmind.com/pics/Marvelmind_ ... manual.pdf - Stable “Z” for drone – settings and recommendations chapter

- We also have a tutorial video about drones on our YouTube channel - https://youtu.be/1qSzymlwFfQ?t=247

Post Reply