hedge updates in distance table, but not moving on screen

Frequent questions asked online, offline, in forums are answered here
Post Reply
crf
Posts: 2
Joined: Thu Jul 16, 2020 12:39 am

hedge updates in distance table, but not moving on screen

Post by crf »

Hi I set beacon1 and beacon3 coordinates manually, and hedge2 updates in distance table but on screen hedge2 sits at 0,0,0
while the distance table is at 3.888,3.831
why is the hedge2 not moving while the numbers distance table are changing?
what am I doing wrong?
hedge2 not moving.jpg

smoker77
Posts: 327
Joined: Sat Feb 06, 2016 4:03 pm

Re: hedge updates in distance table, but not moving on screen

Post by smoker77 »

Hello,

Try to assign service zone for the submap, refer to the operating manual to learn about service zones.
Without service zone, system can reject position results, because distances from mobile beacons to stationary is a lot higher than distance between stationary beacons.

If this will not help, please give us some more information:
1. What architecture do you use - IA or NIA? Version of software?
2. Have you frozen submap/map?
3. Attach file generated by 'Save map' button in dashboard to the reply, we will check the settings.

Also we don't recommend using address 1 for beacons, because it is used for modem by default.

Post Reply