Page 1 of 1

Cannot sync hedgehog in two submaps

Posted: Wed Apr 28, 2021 11:37 am
by GeorgeFlorian
I have the Super Starter Set NIA-3D 868/915MHz which contains:
1x Modem HW4.9 915
5x Super Beacon 915-31.0-IMU

I have installed everything from marvelmind_SW_2021_01_31. The tech-support checked this and the install is correct.

I am trying to create two submaps: each for one room. I am following this guide: https://www.youtube.com/watch?v=FXvlDZkxkUU
I have tried syncing the beacon before and after drawing the Service Zone. The result is the same.

The problem is that when I try to make a second submap and sync the hedgehog by pressing the M2 button, the mobile beacon and the orange one start jumping all over the place and it's impossible to sync them.

The beacons placement:
Room1:
Image
Room2:
Image
Screenshots from the dashboard with each individual submap working properly:
Submap0:
Image
Submap1:
Image

Video demonstrating what happens when I activate both submaps at the same time:
https://youtu.be/KYGmzbXNA8w

IMPORTANT: The mobile beacon did not move through the entirety of this experiment.

Map file: https://file.io/IuMuRFjMxETb
I would've attached it to the post, but the forum does not accept .ini files.