Page 1 of 1

Please advices of regarding the Marvelmind_Starer Set_HW_V4_9

Posted: Mon Apr 05, 2021 6:19 am
by Toshiyuki.Okabe
We need some advices.
We have the Marvelmind+Starer+Set _HW_V4.9(915MHz)System.
We have set up FW and Ultrasonic frequency individual unit into the Model, Beacon, Super, Beacon.
However, we do not display colors to make on Dashboard.
Probably we have made same mistakes setup parameters.
Please refer to the attached file.
But we did not find parameter of mistake.
Could you please let us know mistake of parameters.

Re: Please advices of regarding the Marvelmind_Starer Set_HW_V4_9

Posted: Wed Apr 14, 2021 8:46 pm
by smoker77
Hello,

Unfortunately the file was not attached.
If the forum engine rejects the file, please upload the file to some file hosting and place here the link to it.

The best way after uploading the firmware to all beacons and modem is following:
1. Connect every beacon and modem to dashboard via USB and press 'default' button. For modem press 'erase map' in addition.
2. Don't change ultrasonic frequencies for the beacons. If you already changed them, please setup same frequency as shown on the bottom of the beacon. Beacon can normally work only on its own frequency, don't change it.
3. Build the map as described in operating manual (section 4.2):
https://marvelmind.com/pics/marvelmind_ ... manual.pdf
Don't forget convert one or more stationary beacons to mobile:
https://www.youtube.com/watch?v=A4aRsjH2-_E

Re: Please advices of regarding the Marvelmind_Starer Set_HW_V4_9

Posted: Fri Apr 16, 2021 3:44 am
by Toshiyuki.Okabe
We have uploaded my parameters.
Could you let us know advice.