Position of the hedgehog on each submap not showing, despite pressing the "M2" Button

Frequent questions asked online, offline, in forums are answered here
Post Reply
tommclean
Posts: 1
Joined: Fri Mar 12, 2021 3:02 pm

Position of the hedgehog on each submap not showing, despite pressing the "M2" Button

Post by tommclean »

I have set up two sub maps near eachother in a small room:

Image

If I turn off the stationary beacons in submap 1, the position is shown on submap 0. If I then turn off the beacons on submap 0 and turn on the ones on submap 1, the position is shown on submap 1. When I turn both submaps on and press the "M2" button, it only ever shows the position in one of the submaps. For instance, if I now add a service zone to submap 1, the position is shown on submap 0 instead

Image

How can I make the position on each submap show at the same time, so I can align the submaps?

Thanks.

smoker77
Posts: 367
Joined: Sat Feb 06, 2016 4:03 pm

Re: Position of the hedgehog on each submap not showing, despite pressing the "M2" Button

Post by smoker77 »

Hello,

Do you use IA or NIA system?
What is the vertical line from beacon 2 on the screenshot - is this a service zone of some submap?
If it is a service zone of submap0 (zone with only two points), mobile beacon can't be located inside.
Are both submaps and the map frozen?
We will check the issue on our side, but please clarify these questions.

Post Reply