Connection problem between Beacon and Arduino

Frequent questions asked online, offline, in forums are answered here
Post Reply
YoungFenix
Posts: 5
Joined: Wed Aug 21, 2019 10:17 pm

Connection problem between Beacon and Arduino

Post by YoungFenix »

Hello,

my Beacon was connected via UART but unexpected it stopped send DATA, I tried to change the Beacon and the Arduino but the problem continued. I want to know if there's some configuration in the Dashboard I could have changed that can causing this problem. The Baudrate are adjusted, it isn't the reason of the problem

Thanks

smoker77
Posts: 322
Joined: Sat Feb 06, 2016 4:03 pm

Re: Connection problem between Beacon and Arduino

Post by smoker77 »

Hello,

Some assumptions:
1. Do you have a tracking in dashboard?
Mobile beacon sends location only when its position is updating, so you need to achieve tracking, before trying to read data.
2. Check 'Streaming output' parameter in 'Interfaces' section of settings of mobile beacon in dashboard.
Here should be 'USB+UART' option for sending data via UART.

Post Reply