Page 1 of 1

drone exceeds meshing with marvelmind

Posted: Thu Nov 08, 2018 9:24 pm
by jesuscardosito
I recently started using marvelmind with a drone, I did the steps of some tutorials but when starting the flight inside my mesh the drone went looking for a point. Any recommendations about marvelmind and beacons. I am using mission planner marvelmind pixfalcon + raspberry pi 3 :roll: :roll: :roll: :roll:

Re: drone exceeds meshing with marvelmind

Posted: Fri Nov 09, 2018 7:32 pm
by smoker77

Please see the instruction for integration of Pixhawk with Marvelmind system: ... Manual.pdf

Also please check this topic on the forum, may be your problems were already solved by other customers: ... ?f=2&t=808

If not helps, please share more details about your case: what firmware do you use, can you get GPS lock or not?
Did you achieve good tracking of the drone in dashboard?