Marvelmind Robotics forum

Hello,

LEDs made for basic indications:

- First LED in on while power supply connected (charging)
- Second LED blinks with update rate frequency while tracking, and blinks sometimes when beacon is turned on - to show that it's alive
- Third LED is not in use now, as I remember

Hello,

As I can see, may be the map is not frozen or so.

Please, check our Operating Manual - https://marvelmind.com/pics/marvelmind_ ... manual.pdf - Starter Set IA-02-3D chapter, and do step by step.

Hello, Did you use the Operating Manual - https://marvelmind.com/pics/marvelmind_navigation_system_manual.pdf - Your Starter set starting up chapter? It describes how to launch step by step in details. Please, follow the manual carefully and launch simple configuration using it, before you start do ...

Hello, - Can you please provide the real photos of the installation. Maybe will notice something incorrect - Did you press the default button for every device in the system after SW update? More about default and correct SW update you can find in the Operating Manual - https://marvelmind.com/pics/ma...

Hello,

We faced that before. Beacon may be over-discharged.

Please, check the Operating Manual - https://marvelmind.com/pics/marvelmind_ ... manual.pdf - Mini-RX Beacon chapter or Troubleshooting chapter.

Well, thanks for detailed post. 1) As I can see, your beacons placed on walls, but on videos mobile beacon goes out of bounds. Is it really possible? If not, then there is some distances mistake (between stationary beacons), try to check that distances and enter it manually. 2) Not really clear why ...

Hello, Yes, it's the same SW as for Industrial Super-Beacon. Board is the same in your case (you have pre-installed Super-Beacon SW and can be sure that Super-Beacon SW is suitable for your beacons) You are right to be very careful with it, some users may have Industrial Beacons with previous HW ins...

Hello, General recommendation for map building - Wake up beacons for SM1 - build SM1 - freeze it, lock it (green square near to "freeze submap" button). Create SM2 - Wake up beacons for SM2 - build SM2 - freeze it, lock it. And etc.. Otherwise, it can jump somewhere, or new beacons can try to ruin p...

Hello,
Please do the DFU programming for the first time you use Modem HW v5.1.
DFU programming process described in details in the Operating Manual - https://marvelmind.com/pics/marvelmind_ ... manual.pdf - SW update chapter.

Hello, did you press default for every device after SW update?

Also it is good to check if distances are correct. Please check it, and if it is wrong - use manual distances input